Memmert Precision incubator INE 700 - 416 L

Even slight temperature deviations in the working chamber of an incubator may cause a test to fail. For this reason, the heating and control system of Memmert incubators are perfectly adapted to each other. During heating up and cooling down as well as in running operation, all appliances precisely keep the desired parameters within the smallest tolerance limits. Not only at one measuring point, but in the entire working chamber.

Standard equipment

Ventilation and Control

--natural convection

--continuous adjustment of pre-heated fresh air admixture

--vent connection with restrictor flap

--fuzzy-supported PID microprocessor controller with integrated auto diagnostic system with fault indication

--solid state switching unit

--2 Pt100 sensors Class A in 4-wire-circuit, mutually monitoring and taking over the performance at the same temperature value

--digital 7-day-programme-timer with real time clock, precise minute setting, for one set value or ramp operation in combination with:

--integrated digital timer for tempering profile with max. 4 segments, each segment adjustable from 1 min to 999 hours: DELAYED ON ,HEATING UP , HOLD or HOLD set-temperature-dependent with guaranteed holding time, COOLING DOWN

--"Loop" function to repeat profile 1-99 times or endless

--digital display (LED) of all set parameters, such as temperature, weekdays, time, programme status and set-up values

--resolution of display for set value and actual value 0,1 °C

--long-term logging (ring store) of all relevant data, GLP-conforming as data logger - 1024kB

--serial interface RS 232 including MEMMERT Software "Celsius" for programming and documentation

--incl. works calibration certificate for +37 °C

Triple Overtemperature Protection

--in case of overtemperature due to failure, the heating is switched off at approx. 3 °C above the set temperature (fixed value)

--independently working, digitally adjustable electronic overtemperature controller TWW protection class 3.1

--resolution of display and setting accuracy: 0,1°C

--mechanical temperature limiter TB protection class 1 switching the heating off at approx. 10 °C above max. oven temperature

Textured Stainless Steel Casing

--w x h x d: 1190 x 1080 x 650 mm

--fully insulated stainless steel doors with double locking and 4-point adjustment

--inner glass doors

--rear zinc-plated steel

Interior - Heating Concept

--w x h x d: 1040 x 800 x 500 mm, 416 l

--easy-to-clean interior, made of stainless steel, reinforced by deep drawn ribbing with integrated and protected large-area heating on four sides

--2 stainless steel grids

Temperature Range

--from +30 °C (however, at least 5 °C above ambient) up to +70 °C

Voltage / Power Rating

--230 V (+/- 10%), 50/60 Hz

--ca. 1.800 W (during heating)

--adaption of effective heating power depending on the set temperature

Packing Data

--net weight approx. 131 kg

--gross weight carton approx. 156 kg

--dimensions approx.: carton w x h x d: 134 x 131 x 85 cm

--the appliances must be transported upright

Accessories

--Perforated stainless steel shelf E0(x)

--Stainless Steel Grid (for good air circulation) E3(x)

--Interface USB instead of interface RS232 W3

--IQ check list with works test data for oven as support for validation by customer Q1

--OQ check list including one free-selectable temperature distribution survey to DIN 12880: 2007-05 (size 200/300: 9 measuring points, size 400-800: 27 measuring points) with works test data for oven as support for validation by customer Q2